Skip to content
checkmyracket

Sport

Tennis

How we calculate swingweight

Updated

In short, how does it work?

The racket hangs from its top string and swings like a pendulum. How long one swing takes depends on the racket’s weight, its balance point, and how its weight is spread along the frame. From your four measurements we work out its moment of inertia about the hanging point, then move it to the standard swingweight axis 10 cm from the butt.

What do the symbols mean?

Symbol Meaning Unit
M Static weight of the racket kg (you enter grams)
BP Balance point, measured from the butt cm
Lp Pivot: butt to the bottom of the top string the racket hangs on cm
d Lp − BP, how far the balance point hangs below the pivot cm
T Time for one full swing (the period) s
g Acceleration due to gravity, 980 cm/s²
SW Swingweight, about the axis 10 cm from the butt kg·cm²

What is the formula?

  1. Moment of inertia about the pivot, from the period of a physical pendulum: Ipivot = M · g · d · T² / (4π²)
  2. Move it to the balance point (parallel-axis theorem): Icm = Ipivot − M · d²
  3. Move it to the swingweight axis 10 cm from the butt: SW = Icm + M · (BP − 10)²

The pendulum relation in step 1 is the standard one from physics, and steps 2 and 3 use the parallel-axis theorem.

Can you show a worked example?

Take a racket that weighs 300 g, balances at 33 cm, hangs from a string 64 cm from the butt, and takes 1.394 s per swing:

  1. d = 64 − 33 = 31 cm
  2. Ipivot = 0.3 × 980 × 31 × 1.394² / (4π²) ≈ 448.6 kg·cm²
  3. Icm = 448.6 − 0.3 × 31² ≈ 448.6 − 288.3 = 160.3 kg·cm²
  4. SW = 160.3 + 0.3 × (33 − 10)² ≈ 160.3 + 158.7 = 319.0 kg·cm²

Our automated tests check that the measurement guide gives 319.0 for these numbers.

How is the swing time measured?

  • Tap timer: you tap each time the racket passes the middle moving the same way. 11 taps mark 10 full swings. We fit a straight line through all 11 tap times and use its slope as T, so one late tap at the start or end matters less than if we only used the first and last.
  • Stopwatch: you enter how many swings you counted (5–30) and the total time, and T = total ÷ swings.

Timing 10 swings and dividing by 10 gives a more accurate period than timing one, which is what both modes do.

What checks run before a result is shown?

Check Why
Each value is in a plausible range for an adult tennis racket: weight 200–400 g, balance 28–38 cm, pivot 55–72 cm, swing time 1.2–1.7 s Catches typos and wrong units
The pivot is further from the butt than the balance point Otherwise the racket can’t hang and swing
The result is physically possible (Icm above zero) Catches combinations of numbers no real racket can produce
Tap timer: every swing is within 10% of the median swing A missed or extra tap shows up as an uneven swing; we ask you to time again
Tap timer: taps less than 0.2 s apart, or from a second finger, are ignored Stops a palm or second finger counting as a swing

These ranges and thresholds are our own choices, not industry standards. We may tune them as we learn more.