Measure a racket’s swingweight
Four measurements with a kitchen scale, a ruler and two chopsticks. About 5 minutes.
Weigh it as you play: strung, with overgrip and dampener on.
Balance it on a table edge, mark the spot, and measure from the butt cap.
More tips
How to find the balance point at home
1Find a straight edge
A table edge works best. A round pencil lying on the table also works.
2Slide until it’s level
Lay the racket flat across the edge. Slide it slowly until it rests level without tipping.
3Mark the spot
Put a finger or a small piece of tape on the frame right above the edge.
4Measure to the mark
Measure straight along the handle from the butt cap to the mark.
- Keep the overgrip and dampener on, as for the weight.
- Try it twice. If the two numbers differ by more than about 0.5 cm, do it once more.
- No table edge? The spine of a ruler or a round pen on a flat surface works too.
Push two chopsticks through the strings just under the top cross string, one each side of the centre. Rest them over a table edge, let the racket hang, and measure from the butt cap to the bottom of the top string.
More tips
How to hang the racket
1Two chopsticks
Two chopsticks or pencils — smooth, straight and the same size.
2Under the top string
Push them through just under the top cross string, one each side of the centre, not touching the long main strings.
3Use a table edge
Lay both chopsticks over a table edge, put a heavy book on the inner ends, and hang the racket by its top string on the outer ends.
4Measure to the string
From the butt cap to the bottom of the top cross string, where it rests on the chopsticks. Even 1 mm matters.
- Nothing should touch the racket while it hangs.
- The racket needs about 70 cm of free space below the chopsticks; a table or kitchen counter is high enough.
- Measure twice; the two numbers should match.
Swing time
Push the handle straight forward 3–5 cm. Tap once each time it passes the middle moving right — 11 taps for 10 swings.
Fill in the first three measurements first.
More tips
How to time the swings
1Let it hang still
Start with the racket hanging still, straight down.
2Push the handle forward
Push the handle straight forward, not sideways — only 3–5 cm.
3Tap one way only
Tap when it passes the middle moving right. Not on the way back.
411 taps = 10 swings
The first tap starts the clock, then 10 more taps.
- Stand to the side: it should swing front-to-back, without twisting.
- After the push, wait 2–3 swings before you start tapping.
- If the taps are uneven, just time again — it takes about 15 seconds.
Swingweight
—kg·cm²
4 more to go
- Weight
- Balance point
- Pivot
- Swing time
How do I measure swingweight at home?
Weigh the racket, find its balance point, hang it on two chopsticks just under the top cross string, and time 10 small front-to-back swings. The tool above turns those four numbers into swingweight in kg·cm², using the physics of a pendulum.
- Weigh it as you play it: strung, with grip and dampener on.
- Balance it on a table edge and measure from the butt cap.
- Hang it on two chopsticks under the top cross string and measure to the bottom of that string.
- Push the handle forward 3–5 cm and time 10 swings.
What is a good swingweight?
There is no single best number. A higher swingweight feels more stable at impact but is slower to swing; a lower one is quicker and easier to handle. Most adult tennis rackets measure roughly 300–350 kg·cm², with around 320 in the middle.
| Swingweight (kg·cm²) | How it usually feels |
|---|---|
| Below about 300 | Very maneuverable, quick to swing |
| About 320 | Middle of the road |
| About 350 and above | High: stable, harder to swing |
How accurate is a home measurement?
It is an estimate. The method is standard pendulum physics, but we have not yet compared it with a pro-shop machine. Measure two or three times and use the average; the pivot distance matters most.
Should I measure it strung or unstrung?
Strung, as you play it. Strings add weight across the head, far from the handle, so a strung racket has a higher swingweight than the same frame unstrung. Published specs don’t always say which they are, so compare like with like.
How we calculate
The formula, the two-chopstick method, a worked example, and the checks we run.
Read the methodGlossary
- Swingweight
- How hard a racket is to swing, about an axis 10 cm from the butt cap.
- Balance point
- Where the racket balances, measured from the butt cap.